The instructor will be reaching you 2 things, S and Crank course.
S course: Need to exit in less than 11 seconds.
Crank course: Need to exit in less than 6 seconds.
S Course:
Wait in the queue to go 1 by 1. Press left signal.
Before you move off, check left blindspot.
Once you are about to turn left to go into S course,
be in Gear 2, release clutch then maintain the same speed and press foot-brake all the way.
Do not open and close throttle during the S course.
So when you exit the S course, release both throttle and foot-brake when you turn left.
BUT brake, stop and Gear down to 1 only when you see incoming vehicles on your right.
Most importantly is never look down to the ground because you can't see ahead and you may hit the kerb.
So be sure to maintain the same speed and hold onto the throttle during the S course. (I passed at one go.)
Crank Course:
Same thing as S course.
Wait in the queue to go 1 by 1.
Press right signal and check right blindspot before you move off.
Be in Gear 2 before you turn right into the Crank course.
If you can do the S course well then you definitely can do the Crank course too.
It's all about turn right, go straight then turn left.
And one important thing that instructor told us,
always remember to look up to where you want to go BEFORE you increase your throttle. (I passed at one go.)
Stage 4.02
It's all stages that you practiced from 1.01 to 4.01.
Step 1. Lane change from Lane 1 to Lane 2.
Step 2. Go up and down slope.
Step 3. S and Crank Course (Be in less than 11 seconds for S and less than 6 seconds for crank)
Step 4. Plank and Pylon (Be more than 7 seconds for plank and less than 9 seconds for pylon)
Step 5. E-brake (Don't brake too hard and don't clutch in too early)
You will do few rounds each step as instructor want to make sure you do correctly.
Don't go to Step 2 yet until the instructor tell you.
Don't forget to do blindspot.
Very important as it can minus your demerit points if you fail to do so.
Keep calm and ride on. (I passed at one go)
No comments:
Post a Comment